RC10Talk - The Net's Largest Vintage R/C Community

Looking verrrrry nice Mini, those parts are going to good use!!

Cheers

Darryn

minimini wrote:

cochecito wrote:Hi mini, are you thinking to use B44 cvd in the rear ?

I am going to use the Dynotech Klein arms........the size of the cvd still not decided yet.........

A build of this caliber (ie worlds chassis/4-10) deserves RPM arms in lieu of the Klien arms

very nice project, keep going

Charlie don't surf wrote:

minimini wrote:

cochecito wrote:Hi mini, are you thinking to use B44 cvd in the rear ?

I am going to use the Dynotech Klien arms........the size of the cvd still not decided yet.........

A build of this caliber (ie worlds chassis/4-10) deserves RPM arms in lieu of the Klien arms

yes........this is a good idea........

but ..........RPM worlds arms are not easy to get now.......

now comes to the front legs...........dug out a set of RPM worlds arms from my RC10 parts drawer recently........

replaced the original C-hubs with aluminium ones........which can use 5 x 8mm flanged bearings x 4........

what aluminum c hubs are you using? i did not know there was a aluminum replacement to the m.i.p. ones. do you have the steering knuckels to mach as well?

That's looking really trick - can't wait for more updates.

Mini, I have a rear set and kit if you need-

wyldbill wrote:what aluminum c hubs are you using? i did not know there was a aluminum replacement to the m.i.p. ones. do you have the steering knuckels to mach as well?

no direct replacement to the original MIP ones.........

the aluminium C-hubs were taken out from an optima.........I need to enlarge the hinge pin holes to 1/8"..........& actually I did a lot of fine modifications in order to smoothly fitting them on the RPM arms.......

probably I will use the TC3 steering knuckles to replace the original .........

i believe that a few guys on here were using losi touring car caster blocks and knuckels as a replacement with some success but i am not sure wich ones.

good plan on the tc3 knuckles. Looking fantastic!

spent few hours today ......... assembled the front end..........with the blue anodized aluminium steering knuckles (by SQUARE)........... BJ4 shinny bones with TC3 outer parts..........plus my favourite RCPS turnbuckles & Yokomo wheel adaptors........

This a great high tech build...Love the details

great work

I was busy in the past few months, got no time for this project

With reference to Miguel's RC10 front tower, I decided to re-do mine in order to make it as strong as possible.

Need to polish the shinny edges later.