Project RC250 Club Racer

[Taylorm]

The motor plate also looks quite nice, with countersunk/recessed screws on the bottom and areas milled out for weight savings.

Do you guys think that the milling was done by AE or the previous owner?

.....milling work NOT FACTORY............I have a bunch of NIP servo savers for this car if you want one??????.........PM me, Matt Taylor..nevermind.............just saw the pic of the original 'saver.......Matt

[RC10resto]

Thank you for the offer and clarification - much appreciated!
but as you saw i have it covered
Brian