Old RPM RC 10

[Sharkman]

Fellas,I just about finished this one , still needs a few goodies but she's close. "A" chassis drilled for Stealth,RPM Rear bulkhead w/ a-arms,and up-rights,wide front arms,steering bell-cranks,and a set of ..... yup RPM white ball-cups.Lastly the only pair of T-craft buckles I own.I have a line on a new motorplate (un-hacked),and a single t-craft buckle for the center link.I have absolutely zero gold shocks anymore,so teamz will have to do for now,the 1/4" CVD's were just new and in stock. Hope you like it.

[Sharkman]

nudder one

[Sharkman]

nudder two

[Sharkman]

nudder three

[Sharkman]

last one

[justinspeed79]

Nice!

[superfly]

AHHHHH that white plastic!!! SO BRIGHT!!!! SO NICE!!! I"M BLINDED!!!! Nice car boss

[scr8p]

looking good dan.

if that line on a tie rod for your bellcrank falls through, i got ya covered.

[shodog]

looks like someone has a secret stash of tecnacraft turnbuckles

[scr8p]

looks like someone has a secret stash of tecnacraft turnbuckles

nope, just that one.

[teshreve]

I didn't know RPM made bellcranks. Those look pretty nice.

[carloco8]

I didn't know RPM made bellcranks. Those look pretty nice.

Yup, bearing and non-bearing. White plastic had bearings and black plastic had no bearings, right guys?

[Sharkman]

Thanks all for the flowers. Carlo' I remember seeing white peices somewhere,not sure of the plastic/bearing difference though.I'd be interested in a white set if this is the case.I'd trade the black with a bit of coin

Jason,.Thanks for lookin out.I'll get with you asap if the line "breaks" TTYS!!

[carloco8]

Sorry Sharkman, I don't have either type, lol. I'm just basing my reference off of seeing them on ebay (both types) and the bearing types on scr8p's and hoopty's rpm 10s.

Btw, nice car! I noticed that you have one of those neoprene gaskets on it too!