evader parts inter change

[lowrydesign]

has any one tried and modifying a rear pivot block chassis plate off the evader to fitt the xx series?

http://www3.towerhobbies.com/cgi-bin/WTI0095P?FVSEARCH=DTXC6978&search=Go



a lil cutting and drilling maybe??

[Mr. ED]

backside looks ok, but maybe you better try to get some dimensions from duratrax.
Their contact details are in the same page on the tower site.
I had an eye on that part for another project, where did you find this 3d drawing of it?

[lowrydesign]

here....

http://manuals.hobbico.com/dtx/dtxd29-exploded.pdf

[wyldbill]

i think the anodized evader pro rear plate would fit better and it has extra holesand arm mounts to play around with rear toe. here check it out
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHWN3&P=7