Created a small adapter to allow the Losi 22 5.0 SDSH Slipper (p/n: TLR232085) to work comfortably on the top shaft of XX/XXT transmissions.
The adapter adds 10mm of space between the spring and washer/nut so you can use the full range of compression on the slipper spring without interference or slop in the parts that stack up.
Installation is simple install the slipper plates, pads, spur and spring from the SDSH kit as show in the kits instructions. This part goes between the spring and washer (p/n: TLR232083). The washer will press fit into the conical side of the adapter. Then install the original 4-40 lock nut on the shaft after the washer.
You can download the model to print from the Cults3d project page, https://cults3d.com/:2317927.
--
Sean
LOSI 22 5.0 SDSH SLIPPER (TLR232085) TO LOSI XX ADAPTER
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 433 Views
-
Last post by splaice
-
- 6 Replies
- 776 Views
-
Last post by Bormac
-
- 34 Replies
- 3833 Views
-
Last post by RCveteran
-
- 3 Replies
- 1126 Views
-
Last post by Asso_man!
-
- 10 Replies
- 1646 Views
-
Last post by Caine
-
- 3 Replies
- 1537 Views
-
Last post by TRX-1-3
-
- 10 Replies
- 2132 Views
-
Last post by pedrolucero
-
- 11 Replies
- 2462 Views
-
Last post by jamin
Who is online
Users browsing this forum: No registered users and 1 guest