RC10 gold pan

[michiganionia]

I changed out the rear suspension mounts because one was cracked, when I took the old ones out I noticed somebody had cut them down, why would they do that?

Also does anybody know what these black rims are? I striped one of them out and I bought some new ones from j concepts but they rub on the shock tower.

IMG_0157.jpg (66.11 KiB) Viewed 796 times

IMG_0157.jpg (66.11 KiB) Viewed 796 times

[helbnd1]

I can't see from the pictures of the wheel that well, but they're possibly b4 wheels. Rubbing where the lower shock mount attaches to the a-arm, correct?
The front hole of the suspension mount was probably cut off to run the short wheelbase location without having to notch the original bulkhead.

[michiganionia]

yes that's where its rubbing, what wheels will work?

[JosephS]

yes that's where its rubbing, what wheels will work?

J- CONCEPT mono wheels might work https://www.amainhobbies.com/jconcepts-mono-2.2-rear-wheels-white-4-rc10-jco3404w/p1157761

can you take off the wheel and show the axle that it is attached to?

[juicedcoupe]

Does that car have rear hex conversion?

If so, use Traxxas 7171 wheels.

[JosephS]

Does that car have rear hex conversion?

Screenshot_20220809-042441_Samsung Internet.jpg

If so, use Traxxas 7171 wheels.

That's why I was curious about the axle picture. For rears with the 3/16 axle it seems easy enough to switch from hex to pins by putting the hex in the wheel.