This is a c stamp, with a copper head motor, modern ESC, Spektrum RX running 2S, and of course the new Jconcepts Protector body and Mono wheels. Its # 8/9 out of my goldpan restorations.
Rctommy wrote: ↑Sun Jun 20, 2021 1:32 am
This is a c stamp, with a copper head motor, modern ESC, Spektrum RX running 2S, and of course the new Jconcepts Protector body and Mono wheels. Its # 8/9 out of my goldpan restorations.
That looks really nice. When you say 8/9 do you mean you have one more left?
I have a few T3 runners so I have collected quite a few parts of the years. My daughter is getting to the age where I thought I'd put a truck together for her too. After digging thru my stuff I discovered I have enough parts to build a truck with...
Last post
Cool build you've got. I've become a big fan of the T3/B2/3 series over the past year. I am nearly done with my T3, and currently working on my B3.
That's nice! I believe you picked up a B3 from me in 2021. My all new build I did similar to my T3...
Even though this is technically a buggy, I'm doing a truck conversion with it.
The plan is to build as much of it from my parts/junk boxes as possible. Of what you see here, the transmission ($40 parts trans)and rear control arms are the only...
Last post
Lookin' good! At first I thought this was gonna be a straight 10T build but it's more of an old school conversion! I fondly remember the truck conversion wars from bitd. I snapped up an Eagle right when they came out. Looking back on it now, all it...
I was going to start disassemble and clean my 10T when I had a thought. Do I have enough spare parts to put another tub together? The answer of course was yes. It may not be pretty or complete(yet) :D But it has some cool stuff on it.Nothing was...
Last post
Thats pretty cool that you built that with spare parts man. I need to buy some more parts lots my stock pile is looking a little low. great job
Hey guys. I've been updating some of my RC10s. Also, I moved to a new, bigger house back in early 2021. This means that I've been able to organize all of my cars and parts. I've found that I had lots of stuff squirreled away including plenty of RC10...
Last post
Also, I moved to a new, bigger house back in early 2021. This means that I've been able to organize all of my cars and parts.
So I am just getting back into this with my kids since about the time when these Masami cars first hit the stage, so this is probably a bit of a stupid question.
Where would be a smart place to get the parts to complete one of these chassis kits. I...
Last post
You would need someone willing to sell you a complete set..
You re looking at ..expensive..
Kit 200
3d parts 120
Hingepins and turnbuckles 60
Shocks 80
unis and misc parts (bearings etc..) 100
Stealth, motor plate etc 80
Here are some picture of my RC10DS that I put together from parts I obtained. I have a few custom parts on it. The transmission has a B4 topshaft with Avid slipper. I used RC Carbon Works shock towers. In some of the later pictures you will see that...
Last post
Haven't had a chance to run it other than on my hardwood floors. I am hoping to hit the local indoor track in the next couple of weeks. I don't know if they will let me race it as they are all 4wd, but I should be able to run it during practice....
Bing [Bot] and 1 guest