Yokomo 870C 2.2 Narrow Front Wheels Available.

[Synergy]

JC Racing have just released their 2.2 narrow front 870C/YZ10 front wheels, so you can now buy 870c/YZ10 rears as a pair and these as a pair for your TH-1 equipped pre T2 RC10

https://www.jcracingproducts.co.uk/wheels/yokomo-870c-yz10-narrow-fronts

[winner_evo]

I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel.

[Synergy]

I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel.

Let them know, if there’s a manufacturing issue they would want to rectify it immediately

[sandkil]

I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel.

Could the poor fitment in the wheels be a case of mixing millimeters and inches on the bearings?
Pretty sure these wheels uses 3/16” X 3/8” bearings (AE3977)

[Synergy]

I’ve spoken to JC Racing on this topic, they will check and rectify this tolerance issue with the next production run. They were pretty happy with the fit believing it to be comparable to other manufacturers tolerances but will address and tighten it up.

I have quite a few sets of the front wheels for the original RC10 and have not found this issue, I cannot speak for the B2 narrow wheels.

[winner_evo]

I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel.

Could the poor fitment in the wheels be a case of mixing millimeters and inches on the bearings?
Pretty sure these wheels uses 3/16” X 3/8” bearings (AE3977)

I am using the 3/16 x 3/8 bearings, I removed some from associated worlds re re wheels to double check. It did cross my mind if they'd been manufacured to use metric bearings but I haven't checked that.

[winner_evo]

I’ve spoken to JC Racing on this topic, they will check and rectify this tolerance issue with the next production run. They were pretty happy with the fit believing it to be comparable to other manufacturers tolerances but will address and tighten it up.

I have quite a few sets of the front wheels for the original RC10 and have not found this issue, I cannot speak for the B2 narrow wheels.

Good that they're going to correct it as without, it spoils an otherwise nice wheel option.

Same, I have a couple of sets of their RC10 5 spokes & they're fine, it's just the B2 fronts that have this issue, rears fit fine.

[winner_evo]

I got a set of their new RC10 B2 2.2 wheels with narrow fronts recently. They look really good but the front bearings are really sloppy in the wheel.

Could the poor fitment in the wheels be a case of mixing millimeters and inches on the bearings?
Pretty sure these wheels uses 3/16” X 3/8” bearings (AE3977)

I am using the 3/16 x 3/8 bearings, I removed some from associated worlds re re wheels to double check. It did cross my mind if they'd been manufacured to use metric bearings but I haven't checked that.

I gave the wheels a quick measure, they are not a metric size, just a loose fit for the intended bearing. I would say it's not much but enough for the bearing to not be retained/drop out and give a bit of play.