My 2020 VONATs racers

[Mark Westerfield]

My 2020 VONATs runners are almost ready for this years race. Still working on a RC10T as well. Plan on switching up between rounds and running the funnest ones to drive.

[jwscab]

Looks good!

[Mark Westerfield]

Thanks!

[dldiaz]

Nice Mark!

I'm not sure I follow - are you saying you will have two entries for 4wd, and two entries for stadium truck (including the 10T not shown)?
And you will try different cars in different heats?


I plan to enter at least a couple classes this year, not sure exactly what I will bring yet.

[Mark Westerfield]

Yes, I'll just swap out my transponder between vehicles.

[mikea96]

Would like to see some more pics and details on the XX4.

[stickboy007]

Mark, you need a 2wd buggy and a Classic 4wd buggy!

[pumpkinfish]

is the xxx4 legal now?

[Mark Westerfield]

Last years rules...

"Racetech Motorsports 4wd Buggy
All buggies are limited to cars produced 1997-2004.
10.5 brushless motors only.
Radio gear “electronics” are open.
(Examples: XX4, XXX4, TC3″O”v2, MX4, MR4BC, BJ4, Cat 2000 SE, Lazer ZXS)"

[Mark Westerfield]

Would like to see some more pics and details on the XX4.

I'll put up some more. Looking for anything specific?

[Mark Westerfield]

Mark, you need a 2wd buggy and a Classic 4wd buggy!

I had setup a XX buggy, but I ended up selling it. Maybe if I find a good deal on a nice RC10B2/B3, I liked those cars. I wouldn't mind building another NIX91.

[stickboy007]

Mark, you need a 2wd buggy and a Classic 4wd buggy!

I had setup a XX buggy, but I ended up selling it. Maybe if I find a good deal on a nice RC10B2/B3, I liked those cars. I wouldn't mind building another NIX91.

You should get a Pro-X. Maybe I can build you one

Actually, I probably have more parts to build you a mid-motor Pro-X (different gearbox parts)...

[mikea96]

Just overall pics and setup info.

[Mark Westerfield]

There is nothing significant about the car, it's pretty much box stock. I cut off the hex from the standard front axle, drilled a hole, and put on a B44.3 12mm front hex, and a B44 rear hex on the back to use current wheels. Made my own sway bar and mount.

[mikea96]

Very nice! So are they b44 wheels then?