Is there a 3S lipo that fits nice in the rc10 worlds re re?

[Showcase1186]

Thanks for your help in advance. I've done a search on here with limited luck on here. Is there a 3S lipo that will fit the rc10 worlds car re release without hacking up the battery cups?

Thanks for any help!!!

[yellowdatsun]

The reason you aren't finding any info on it, is that nobody does it. A 2s hi-C rating pack with a fast motor is WAY more than enough for these cars. A 3s system would grenade the tranny in short order.

In addition, they won't fit in the stock battery cups anyways. Maybe length and width if you're lucky, but not height.

[Showcase1186]

What are you running that fits well in 2s

[Lonestar]

Any standard 2S pack... this is what the re-re worlds was designed around

[rcnewbie]

A standard 2s lipo battery pack with deans plug can fit, such as a ovonic 2s 5000mah lipo.

[broodenburg]

A soft shell 3S pack will fit. But I agree with yellowdatsun that this is way too much power. I run 3S with a 8.5 in my T3 every now and then and that's TOTALLY overpowered.

[discgolfer72]

not certain on the buggy , but I run a venom 3s 4000 shorty lipo in a late black parts rc10t . should fit fine in the buggy also
running a dynamite 4900 kv brushless , and the trans is holding out fine . I do keep ripping out the insides of my rear wheels , and tires last 2 runs

[DaveM]

2 cell = Fun

3 cell = Broken Parts

[Dadio]

At the very least your gunna need about 2lbs weight on the front end to stop it lifting the front wheels ! , a good 2s hight C rating race pack is plenty , if you want to go nuts stick a 7.5t or 6.5t brushless motor in it and that's probably still overkill .