Of course white plastics would be epic, but the gold is sure nice to see! Those are the thickest towers I've ever made. They are 3/16 thick. These guys don't mess around nowadays
Sounds like he is leaning towards a Jay Halsey paint scheme
Attachments
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
So I found the lengths that will work. And I know the threads are 4-40 type. I can't seem to find the diameter anywhere. And pardon my ignorance if the diameter is implied with the 4-40 thread type designator. Will they fit the Gen I Traxxas rod...
Last post
The retro turnbuckles start with a 1/8 rod that is turned/rolled with #4-40 threads on the ends. As shown above just under 3mm
I'm building a shelfer and figured, what the hell, I'd do titanium hinge pins and turnbuckles. What kit # do I need to get? I checked out Tower but they list the B4 and SC10 and some others, but not sure if those have compatible lengths for my needs.
Last post
This link is dead. Does anyone have another lead on the RC10 hinge pin lengths?
I often wondered why Associated ditched their heritage of using gold colored anno parts. New image with new times I suppose, but I still prefer the gold. Purchased a new B4.1 ahwile back along with the new big bore shocks and other bits. This will...
picked up a set that says for T2/GT/T3. It is the punished series. When I compare the length they are shorter then my current ones. I was under the impression that the gt and T2 are the same lenght as the 10T..
Last post
....the new set has two diff length. 4 rods are 2-5/8 and two are 2-3/4.
The technacraft I pulled out my box are SHORTER then the all four 2-5/8 by 1/8. Not really much but a 1/4 shorter then the longer two. I'm. Thinking the longer two are good...
Im going to be ordering a full hardware set for the rc10. My biggest question is it worth upgrading parts to this material? Is there any advantage over stainless steel with a good finish? I'll have to determine what all screws I actually need but is...
Last post
don't forget ti doesn't really annodize well, it kind of wipes off.
Found a pretty cool interview on YouTube with Lunsford.
Good to see a few companies like Lunsford, Robinson, RPM, and MIP staying American
00qgJM93bgk
Last post
Very cool. I'm a big fan of Lunsford, and the others you mentioned. I agree it's cool to see them staying American. Not only staying American, but still offering a superior product at a reasonable price.
Several of these fake sites are popping up all over. Gotta be careful these days. Lucky for us most of us know better but I bet they scoop up lots of business from the unknowing