RC10 edinger/cadillac front anti roll bar wire gauge

[bluewormx]

I'm working on a late 1987 race spec car (pre andys arms).

The front anti roll bar. What gauge piano wire did the edinger cadillac era cars have?.

As somebody pointed out in another thread most of the parts to make the roll bar are available from du-bro.
Just stuck on wire thickness.

[a01butal]

3/64"

[bluewormx]

Thanks
I was expecting a measurement in thousands of inch. But that works fine
3/64 = ~.047" or ~1.2mm

Thanks again

[bluewormx]

I just measured an original Edinger.
1.4mm or about 0.055"