It just slips all the time when I hit full throttle, i'll check the pad but the slipper hasn't had much use as I almost always used to run it locked when racing. I think i'll just make a slipper eliminator for it anyway.
Ive read a bunch of threads but cant find just what I'm looking for. What I was wanting to know is this...... I have a stealth tranny but just has the top shaft with no gear or slipper, will the newer slipper (that is being sold) or the custom works...
Last post
For me, I already have a hundred of those bearings, I would have to buy 3/16x3/8 flanged.
in the manual it shows a spring behind the thrust bearing. while rebuilding my 10t diff i noticed that it didn't have one.
so i tore open another stealth and it didn't have one either.
i rebuilt the...
Last post
The spring may be jammed up in the outdrive.
That happened to me with my T3. I thought I lost the spring and looked all over the place for it. I didn't figure out it was stuck in the outdrive until I put a new spring in there and couldn't get the...
I have a late model 10T with a 2.25 stealth. I think for the direction I am going a 2.6 would be a better option for me. Can I just change out the gears inside or do I have to buy a new trans? TIA
Last post
You might be able to fab something but it's far from a drop in. Best bet is to find a cheap T2 donor for the chassis, bulkhead, rear tower and trans. Swap over all your suspension and nose. There was one for around $30 on eBay just a few days ago (I...
So the question here is durability. I'm looking at a trinity d5 flatliner motor for my car. It's the 8 turn version and It's brand new. My question is if my first generation stealth transmission will handle the power and torque of the motor? I don't...
Last post
A new can?? I would be more worried about the armature being burnt from the heat even though it looks just fine to me. So would any mod can work? This motor looks to be about the size of I believe a 380. I'm not really sure. Also how would I handle...
After locating a used upper shaft for mounting the hydra unit on a stealth trans, I'm having having a problem after the complete unit is installed and going to put the rpm gear cover on( cover hits the unit). I knew there was a problem as soon as I...
Last post
Whoa...first of all what is a Hydra drive and how does it improve your tranny?
It’s like a lock up torque converter from a full size automatic transmission. The interior rotor and the housing have vanes and it’s filled with thick shock fluid. It...
I took some time off from my hobbies for the last 4 months or so. I still trolled the board though :roll: But now that things have calmed down I decided to find out what that diff noise was in my RC10 Runner. I ended up needing a new diff. Now I'm...
Last post
are you putting enough diff lube in the holes of your diff gear? also, as you're tigtening the bolt down do it a little at a time and turn both sides of the diff. this way you get all the balls lubed and turning. you'll get better diff feel that...