I wish I were kidding, but I have the perfect set of parts for those bellcranks
This NIX91 runner build has taken a turn today. Here is a photo of it this morning
I went to visit Rod at the shop and ended up at his place after he got off work. This pile to the right of the NIX91 is what I ended up coming home with
A B4 roller that will be scavenged for a couple different runners I have including the NIX91 and a heaping pile to go along with it. The build is not even going to resemble it's current look, it's going to turn out so nice it's going to be hard to run, but it WILL be.
Different electronics will be in place too. I've got a bunch of rearranging to do with a couple different builds to get this one complete. I will show some more detailed pics as I go along.
Technical notes are typical of the other builds. The trans brace had to be shimmed and the top plate front holes had to elongated slightly to relieve stress on the chassis. The 4-40 holes were reamed with a #30 bit. I used a 1/8" to ream the pin hole, but I wished I had something just a hair thicker. The parts don't move completely free and will ream them again with something else once I know what to use.