The broken parts thread
- RC10th
- Approved Member
- Posts: 4703
- Joined: Sat Feb 16, 2013 9:51 am
- Location: Australia
- Has thanked: 50 times
- Been thanked: 1495 times
The broken parts thread
I'm a bit bored and this came to mind.
Show us your broken parts.....
Show us your broken parts.....
I was old school - when old school wasn't cool !
- THE H.P FREAK
- Approved Member
- Posts: 1000
- Joined: Thu Nov 18, 2010 8:12 pm
- Location: Windsor, Ontario, Canada
- Been thanked: 3 times
Re: The broken parts thread
HI!...
Traxxas "T" Maxx to "E" Maxx conversion. Shredded trans gears :

Caster Fusion EX1.5-R (MMM set-up)
Broken front lower "A" ARM :

Broken axles :

MMM ESC meltdown :

Bigwig chassis broken :

Traxxas "T" Maxx to "E" Maxx conversion. Shredded trans gears :

Caster Fusion EX1.5-R (MMM set-up)
Broken front lower "A" ARM :

Broken axles :

MMM ESC meltdown :

Bigwig chassis broken :

102 RC vehicles and counting...
- GoMachV
- Approved Member
- Posts: 12198
- Joined: Sun Apr 29, 2012 10:31 pm
- Location: Twin Falls, ID
- Has thanked: 1081 times
- Been thanked: 3743 times
- RC10th
- Approved Member
- Posts: 4703
- Joined: Sat Feb 16, 2013 9:51 am
- Location: Australia
- Has thanked: 50 times
- Been thanked: 1495 times
Re: The broken parts thread
That big wig looks pretty sad.
I was old school - when old school wasn't cool !
- THE H.P FREAK
- Approved Member
- Posts: 1000
- Joined: Thu Nov 18, 2010 8:12 pm
- Location: Windsor, Ontario, Canada
- Been thanked: 3 times
Re: The broken parts thread
HI!... That's nothing. I've broken a ton of stuff. A lot of my RC stuff I run is for top speed runs. So when they crash it's not pretty. Just have no pics of the bad stuff.gomachv wrote:Something tells me your gonna rule this thread![]()

102 RC vehicles and counting...
- JK Racing
- Approved Member
- Posts: 4618
- Joined: Thu Jul 19, 2007 2:32 pm
- Location: Placentia, CA
- Has thanked: 129 times
- Been thanked: 242 times
Re: The broken parts thread
Front skid/bumper mount AE ProLite 4X4

JRX2


Spun wheel, from the JRX2 above

Busted CVD

RC10 speed run damage



JRX2


Spun wheel, from the JRX2 above

Busted CVD

RC10 speed run damage


--Joey --
Vintage A&L and Factory Works
Old School Racer & Vintage RC Car nut
JKRacingRC.com
Vintage A&L and Factory Works
Old School Racer & Vintage RC Car nut
JKRacingRC.com
- shodog
- Approved Member
- Posts: 3813
- Joined: Thu Oct 05, 2006 3:09 pm
- Location: Washington
- Has thanked: 3 times
- Been thanked: 91 times
Re: The broken parts thread
Here is my broken story. I just put the finishing touches on a new XRay T1 and was out driving it for the first time on the street in front of my house. My neighbor comes up and asks if he could try it. Sure why not I say. So this big Chevy Tahoe is coming towards us from down the street and the RC car is coming traveling in the same direction. Right when the car is even with the truck, he turns into the path of the truck and its promptly runs over by the Tahoe. I couldn't believe what had just happened. In all my years of running R/C cars I've never had one run over. My neighbor was not aware that the servo controls are reversed when coming towards you. He profusely apologized and said he would pay for all the damages. In the end he ponied up for another chassis, battery and motor.








- mk-Zero
- Business Member
- Posts: 1678
- Joined: Fri Jan 03, 2014 2:14 pm
- Location: Orange, CA
- Has thanked: 4 times
- Been thanked: 21 times
Re: The broken parts thread
Tahoe: 1
X-Ray: 0
That was cool of him to pay, I'm sure a lot of guys would just shrug their shoulders.
X-Ray: 0


That was cool of him to pay, I'm sure a lot of guys would just shrug their shoulders.
- DMAT
- Approved Member
- Posts: 885
- Joined: Wed Mar 20, 2013 8:53 am
- Location: Baton Rouge, La
- Been thanked: 4 times
Re: The broken parts thread
I wish I had a picture of my bent motor. not the shaft, the entire motor.
- THEYTOOKMYTHUMB
- Super Member
- Posts: 7072
- Joined: Wed Oct 22, 2008 5:15 pm
- Location: Evansville, IN
- Has thanked: 3450 times
- Been thanked: 1890 times
Re: The broken parts thread
shodog wrote:Here is my broken story. I just put the finishing touches on a new XRay T1 and was out driving it for the first time on the street in front of my house. My neighbor comes up and asks if he could try it. Sure why not I say. So this big Chevy Tahoe is coming towards us from down the street and the RC car is coming traveling in the same direction. Right when the car is even with the truck, he turns into the path of the truck and its promptly runs over by the Tahoe. I couldn't believe what had just happened. In all my years of running R/C cars I've never had one run over. My neighbor was not aware that the servo controls are reversed when coming towards you. He profusely apologized and said he would pay for all the damages. In the end he ponied up for another chassis, battery and motor.


That cracks me up only because it was the first time you had it out. I always figure if I hand somoene my controller then whatever damage ensues is on me. I guess it all depends how you look at it. I had a similar experience with my RC10GT except I was the one driving. I had just gotten past the engine break-in and had only opened it up for a pass or two when the the throttle linkage came loose. It did a couple of donuts and then into a curb at full throttle. I had the body off so parts flew everywhere. It was one of those


"The world looks so much better through beer goggles: Enjoy today, you never know what tomorrow may bring."
Ken
Ken
- THEYTOOKMYTHUMB
- Super Member
- Posts: 7072
- Joined: Wed Oct 22, 2008 5:15 pm
- Location: Evansville, IN
- Has thanked: 3450 times
- Been thanked: 1890 times
Re: The broken parts thread
My E-Savage takes 2 packs and one day after goofing around with it I pulled one of the packs out to find this. I had been jumping it pretty hard that day so I'm not sure if that played a role in the demise of this pack or not, but whatever the case it was done for...


"The world looks so much better through beer goggles: Enjoy today, you never know what tomorrow may bring."
Ken
Ken
- RC10th
- Approved Member
- Posts: 4703
- Joined: Sat Feb 16, 2013 9:51 am
- Location: Australia
- Has thanked: 50 times
- Been thanked: 1495 times
Re: The broken parts thread
The Xray wouldn't have been cheap, I bet he was shocked at the price. Those parts you say he replaced doesn't cover everything dsmaged.
I let a young kid 5ish drive my severely boosted T4 at a BMX track which had had the potential to go totally pear shaped. They had no clue the value of everything but traction was low so I said why not. I figured he'd just mash the throttle and do donuts. Luckily enough the truck survived and the kid didn't crash it, if he could have got it up to speed it might have been a different story however.
I let a young kid 5ish drive my severely boosted T4 at a BMX track which had had the potential to go totally pear shaped. They had no clue the value of everything but traction was low so I said why not. I figured he'd just mash the throttle and do donuts. Luckily enough the truck survived and the kid didn't crash it, if he could have got it up to speed it might have been a different story however.
I was old school - when old school wasn't cool !
- THEYTOOKMYTHUMB
- Super Member
- Posts: 7072
- Joined: Wed Oct 22, 2008 5:15 pm
- Location: Evansville, IN
- Has thanked: 3450 times
- Been thanked: 1890 times
Re: The broken parts thread
I always think it's fun to hand it over to someone and see what happens. To me it's hilarious, but I guess it all depends on your sense of humor. I definitely get butterflies when I hand the controller over to the kids on our street, but they have so much fun with it I just can't help myself. I always get a good laugh out of it too. To most of them cars have 2 speeds; stop and full balls! 

"The world looks so much better through beer goggles: Enjoy today, you never know what tomorrow may bring."
Ken
Ken
- Charlie don't surf
- Approved Member
- Posts: 9211
- Joined: Tue Apr 08, 2008 2:44 pm
- Location: USA
- Has thanked: 265 times
- Been thanked: 363 times
Re: The broken parts thread
I had one of these frag in the exact same way, diff ring failure and all. Odd-LTO_Dave wrote:RPM 2.65 Stealth internals:
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 7 Replies
- 3756 Views
-
Last post by toyranosaur
-
- 148 Replies
- 16464 Views
-
Last post by JK Racing
-
- 550 Replies
- 63093 Views
-
Last post by CrazyRC
-
- 58 Replies
- 4392 Views
-
Last post by justinspeed79
-
- 31 Replies
- 5325 Views
-
Last post by durb69
-
- 11 Replies
- 1527 Views
-
Last post by longboardnj
-
- 18 Replies
- 1775 Views
-
Last post by treehugger
-
- 15 Replies
- 1622 Views
-
Last post by EvolutionRevolution
Who is online
Users browsing this forum: Ahrefs [Bot] and 8 guests