How much is too much?

[Barnfind]

I have an A stamp chassis that already has a few holes drilled into it and I was thinking on making it a basher so I started to look for ideas on this forum and I really like the look of the tubs with the cut down sides but im not sure how much to cut off with out making it to flexible and requiring a chassis stiffener? anybody have any ideas or help on this idea or should I just leave it alone and not cut it?

[RC10resto]

1/4 inch

[scr8p]

ya, 1/4" is more than enough.

[Barnfind]

Thanks for the help

[GoMachV]

I cut just enough to remove the servo access hole everyone seems to drill