Got this servo with a 1980 1/12th car and the Trinity motor with another one. Someone knows the brand of this servo? Never have seen before.
Also what is this Trinity motor? I think looks like an early Epic can but don´t know of an aluminium...
Last post
The motor is a mod motor as you probably know. It's one of the $80 motors as most companies had cheaper mod motors with plastic endbells which were machine wound, not hand wound.
Hi guys Im wondering if the yr4mII motor mount was compatible with yz10 870c buggies or other cars that used the 1 piece style center bulkhead mount? I cant seem to find any pictures of yr4mII to compare. It looks like there was a stick pack motor...
Last post
Is the blue anodised one? I have one of those and found you need a different length of belt.
The spur axle is a bit higher and the boltpattern for the chassis looks the same but is just bit different also. Just enough, so you couldn't use it on the...
got a blue pan rc10GT , stock motor mount mounted to the pan.
looks like im missing some thing ,cuz i cant mount the motor.
on the black pan GT's , theres them little plates that mount to the motor, then mount to the mounts on the tub..
can...
Last post
They are OK for bashing but a little hard to control. Way more than you'll use for power.
Todd
On A stamp pan. On the end with the 2 threaded holes that gets attached to the chassis - why did they extend the plate so far past those threaded holes? What happened to my car is that the end of the motor mount plate hits the chassis resulting in...
Last post
unless your dealing with pristine new out of package or out of box stuff there is always the chance that parts are bent or tweaked a little bit over the years...ive been re shaping tubs and other parts for a few years now taking what would be trash...
I knew yokomo including Magnesium motor mount on yz series cars,but easy Magnesium motor mount easy get oxidation looks old.that yokomo ever made the aluminum motor plate, look very shiny and beautiful.but it has very expensive.I don't how many it...
Last post
I just picked up the team yokomo motor mount with a couple of YR4's. It was in the spare parts bag...but it doesnt look like the belt tensioners were installed in the right places to me. Does anybody have a scan if the installation instructions for...
I've just come to install a brushless motor, in my RC10 Team Car, only to find that the mounting holes on the motor are slightly too far apart for the holes on the RC10 motor plate.
The motor is a Reedy Sonic 540 M3 #269. I bought it nearly new...
Last post
I think the issue is with the old motor plates as brushed motors had a pair of holes side by side which were each slightly off center. The RC10/T motor plate had a fixed lower mounting hole so the motor has to rotate instead of slide to adjust mesh....