Rc10gt brushless/trans questions

[Dirtcar75]

I am wanting to do a rc10gt brushless conversion and was wondering if the gt trans is the same as a typical stelth trans out of say a t3? If soo i could just use a customworks motor mount and spacers and be done! but otherwise i have seen guys use pan can motor mounts and then have to brace them with tie rods and such because of chassis flex any help would be great thanks dj

[romulus22]

The trans in the GT. is completely different than any other so no mount will bolt right up. There was some guy who made a motor mount for the GT chassis but the pan car mount sounds just as easy. Great idea too.

[Dirtcar75]

Ok so what about using like a customworks trans and mount it is pretty much a t3 trans with input shaft out other side

[THEYTOOKMYTHUMB]

Here's mine. A brace for the motor mount would be something I recommend. I only ran mine a couple of times before shelfing it so it wasn't much of an issue for me. Ran strong though. They convert very nicely.
http://www.rc10talk.com/viewtopic.php?f=36&t=7717&hilit

[Dirtcar75]

And its between doing a brushless gt or going out and buying a new 22t

[SRTracer121]

id pick up a 22, why wreck a gt when you can go hammering on a modern car