TCS for Yokomo yz10 91 Works?

[slow_jun]

Will this fit a yz10 91 Works?

[crusaderlyf]

Original works91 comes center shaft like 870C, if you want to use TCS slipper system on works91, you must find rear belt slipper disk and oneway front belt pulley,both are use 2mm belts,like WCS,so hard to find.

[slow_jun]

Thanks yunfei, but will this shaft accOmodate if i can get the pulley ,oneway etc ... The parts used to have a tcs,?i read on here before that a pulley from abothe yoke car is still availble and a diy AE slipper would be able to work.

Just cant find the link

[crusaderlyf]

Sure can work if you can settle the pulley and belt problems.

[Alex B]

You will need the centre pulley, a YR4 version may work the inner plate for the slipper and the outer plate and thrust bearing which I think you could use the original stealth parts. The inner slipper plate is hard to find.