Need Help Finding Correct CVD Length

Post by **LTO_Dave** » Tue Jul 05, 2011 9:46 pm

I've almost finished my 10T MMV truck build, but I need a pair of MIP CVDs to complete it. I'm using an oddball tranny with plastic slider cups and RPM truck arms, which is turning into a nightmare finding axles that fit.

I'm hoping to get measurements on MIP CVDs for other applications from other members if possible so I have an idea of what to purchase.

I need MIP CVDs that accept RC10T/T2/T3/GT 1/4" axles, but are about 1/4" shorter in length than standard 10T CVD bones, which measure 3 & 7/16" from end to end. The ball on the end can be slightly larger than the standard 10T CVD bone, as well.

Any help would be greatly appreciated.

Post by **Charlie don't surf** » Tue Jul 05, 2011 10:31 pm

Customworks right side GSX offset CVD, or maybe the Losi axel half that has a deeper offset

Post by **scr8p** » Tue Jul 05, 2011 10:34 pm

Charlie don't surf wrote:Customworks right side GSX offset CVD

ya, the wide cw bones are the only ones that come to mind. might be a bit too short though.....

RC10Talk - The Net's Largest Vintage R/C Community