Chassis ID & Next Project.

[Prince Steve]

Another one of my projects I plan to start.
added some lines to the body.

[scr8p]

that's an a.r.t. agitator. that was one of the first pancars i had bitd.

[reign79]

scr8p wow a pan car guy i knew you had it in ya

[Prince Steve]

that's an a.r.t. agitator. that was one of the first pancars i had bitd.

Almost there your missing 2 letters???????

[scr8p]

i got a picture of my old one somewhere, but the body is on it.

that's an a.r.t. agitator. that was one of the first pancars i had bitd.

Almost there your missing 2 letters???????

ok, ok. an agitator Jr.

[Prince Steve]

It's the A.R.T. Jr. with Graphite axle- Quick adjust differential. Full bearings. Aluminum Heat Sink Motor Mount. Futaba FP-s132h servo. It is a Junior because the chassis is Fiberglass. The rear end and top plate is Carbon Fiber.
You r very good scr8p

[scr8p]

also, the agitator jr. had a single rear shock where the agitator had 3.... if i remember correctly.

[reign79]

Yes you are correct the agitator had a three shock tipod setup.

[Prince Steve]

OK here is 1 pic with a mystery body..
It's any bodies guess.. Get It! any BODIES...
I know Corny.

I am also taking suggestions on trim color and decal selection. This project has turned to a new direction..
RC10Talk will decide on the outcome of the project ( Minus ) electronics.

Yes Folks I wanted to start this thread so you will help decide it's final look.

[mrlexan]

Bolink Superbird

[Prince Steve]

Bolink Superbird

Darn! I should have excluded you..

[mrlexan]

[Prince Steve]

Well since you answered. Any suggestions

[scr8p]

Any suggestions

make your pics bigger.

[Prince Steve]

Any suggestions

make your pics bigger.

I will try. Suggestions taken. At this point I am using a free online picture resizer an dreducing them to %75. Let me know if this is wrong? Thanks