RC10Talk - The Net's Largest Vintage R/C Community

Oddly I see the original RC10 missing from that list.

Chris

Junior T bodies should be available from Teambluegrove in Canada, I sent them the nos body to make the repros.

Big power and questionable suspension, this is going to be a sight to see and seriously wild ride when it is done! It's probably going to need an exocage to keep that body intact! lol

And my poor bootleg bruiser will likely never see dirt while I own it...

You are not authorised to read this forum.

Hmmm....


I love 3d printers...

Working my way up to modeling the junior chassis....

Well that worked better than I expected, would have been better with a .2 nozzel and black, but it is only a test print, now on to the front!

The painted bodies only cost a bit over 30 bucks, get one and then get the other style bodies

JrxT? lol

BattleTrak wrote: ↑Tue Jun 14, 2022 1:18 pm

WriteDean wrote: ↑Tue Jun 14, 2022 1:13 pm Sure hope you post those STL files! Hint, hint...

clm wrote: ↑Tue Jun 14, 2022 8:35 amJrxT? lol

And put them on Shapeways..

Absolutely, need to massage them a bit first and make sure screw holes and body clip holes work

Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol https://cults3d.com/en/3d-model/game/losi-tru...

:mrgreen: The front kickup has not been sized right and I have not modeled any holes yet but dang if the trans and battery holder did not drop right in! Yes Yes I know I still need to do the bellcrank mounts, this was just a sizing test ;) There are some mounting holes by the rear bulkhead that got ...

If you can find them losi made some open end bell motors for the mini lst which he showed above. They are not the best quality as I have had one have the wiring explode.. But the Team Losi Insane 370 looks good and came in a two pack

Well I think I am done with the rough shape of the chassis although I do need to do the upper brace. I finished them in both styles, Junior and Pro :) Printing will be a bit tedious with them as they do tend to be large, it is probably best strength to print them laying on their side but easier to p...

Got a test chassis printed, I need to adjust the spacing of the holes in the tail a bit but wont be able to do that until next week due to poor internet access.

While working on sizing and carefully placing holes in the chassis file I just did this up quickly.. It is going to be a pain to print.. if anyone does post a picture lol This one is likely going to need to be printed on it's side if you want any chance of it not breaking the first time you hit some...