RC10Talk - The Net's Largest Vintage R/C Community

Decided to revisit this again for some reason and searched and searched with no luck ..... but...... I found it on wayback machine on Team Associateds website.

Buy something to run unless your building a shelf queen, paying that much money on an engine is silly unless you were doing a box art build, and even then the boost chamber isn't "correct" Basically any rotary carb .12 -.15 with side exhaust and an OS/threaded crank will fit (non SG). If y...

That's pretty cool, great story !!! Just check the instructions to make sure a pull start motor will fit. Fuel would be 20% - 30%. The lower the nitro content the larger the tuning window, so maybe start with 20% Tuning will change slightly from day to day depending on conditions, it even could chan...

I wouldn't call half of the cars entered POS's, lol

Great album

With all this fuss it's time to start working on bringing back the Dudgeon

I wonder how ads like this would go today ?

Imagine if people had to build a real RC10 today, there would be an uproar with all of the hand fitting required.

Just get some reasonably fine sandpaper and lay it on something flat like glass or melamine or wrap some sandpaper around a flat stick/block and sand the edges. Once the anno is removed give them a light polish and your set.

I finally had time to paint the body. I have been putting it off time and time again as I couldn't find the motivation to paint it. I found I made some window mask templates last time which greatly reduced the time spent masking. 20250316_010255.jpg Nearly done, I couldn't be bothered masking the ro...

It's a pretty good deepfake as it's not a real SRT looks good with the cut up gearbox and the Sonic

Nice, that's a fun job....

Time to break out the cell matcher and make some matched cells

If you have the pullstart flywheel yes it will.