RC10Talk - The Net's Largest Vintage R/C Community

I think I used B4.1 rear hubs and ended up using a Yokomo bone paired with the AE axles.

Also check NIXCONCEPTS as Niki has a bunch of modified gear for the RC10.

This isn't an RC10T body but the principle is the same. Most "vintage" Associated bodies that I've used seem to fit the front of the truck fine and while tight on the rear shock tower fit without modification. Here is the rear plate I made to accept this Frewer body. I forget what rear tow...

Hard to see but here's an RC10T3 body on a T4.2. 20190107_214051-1024x576.jpg Stock rear mounts, the shock humps fit exceptionally well. 20190107_214108-1024x576.jpg These are the SC10 front mounts to raise the body to clear the 4.2 tower, it should fit the standard tower just fine I would think. An...

Wow, two things....... 1 - How did I miss this thread to begin with 2 - That thing came out pretty good !!!! If you know a part number or feel like rummaging check out the old Traxxas boxes at HH. There were a few bullet parts and quite a few white Traxxas parts (gearboxes too maybe), what they were...

Midway through the B4/T4 run was when the change happened, so if you look at early B4 literature you'll see what LRP/Reedy had to offer. V brush motors such as the Peak Vantage were the last "Big Thing" to happen in brushed motors although it didnt last long at all. It took a little while ...

Synthetic oils have better cleaning properties and "can" create oil leaks in older engines by cleaning away built up gunk that could be preventing a leak. I run Royal Purple Synthetic in all my junk (old stuff) and swear by it, although it is on the upper end of the price scale. Luckily yo...

Just beware, some cars throw a check engine (airbag) code if you remove the seats and need to be reset. As far as exterior/interior car care products I swear by Meguiars detailing products. I would avoid Armor-All on the dash, they got a bad wrap due to cracked dashboards in the 80's, apparantly the...

RC10GT

I wouldn't run them

They were supposed to be extra quiet due to the rubber insulator.

I think it's "normal" and mainly due to lower quality cells or old batteries, they sit there nearly fully charged forever and take ages to finish or fail to "balance"

Make Associated Great Again !

Pull fuel pump fuse

I would say B3/T3 keep vintage and B4/T4 onwards modern

Can't help the addiction Alex

My mailbox still says hello