RC10Talk - The Net's Largest Vintage R/C Community

If Google is right, that's like $430 USD plus shipping. Not terrible for a very limited edition buggy Why not I'll see if I can snag one

They sent the invoice after I made my reservation and it showed I was #10, I'm betting they are sold out by now. Guess we will see! The cost after shipping and PayPal rape was $503

Ding ding ding
Your up Thumbs!

yes, standard red jst plug. Just remember that neutral goes to the center pin on those oldies. Red to the outside of the case.

home made versions of the adjustable CRP motor plates for clod, hornet, frog etc

our version...

Yes 5-40 was common

The QIDI Plus 4 uses smaller notched belts to drive the hotend, so it's able to print in finer resolution than most 3D printers, at this moment in history (everyone will be doing it soon and better too). And I'm derailing the thread again :lol: But just wanted to say, it's an interesting topic. I w...

That's from a losi slipper setup

For me, I like my Bambu X1C's. They have ran flawlessly for me. GreenBaron is getting great prints off his Qidi Plus4 as well but I dont think they have released their multi material system yet. Prusa are also very solid choices, more expensive but a long history of quality. Those are the 3 I would ...

Made some drawings lots more to go.

Some mock ups to test fit parts

Ayk Radiant, the original version before Race Prep made them into mid motor "Pro Radiant"

I need 4788 posts to match Jason, that's my goal for the 20th anniversary next year

Isn't that a smart system?! I love it, and did my fox kit the same way. I will probably continue doing it that way on future kits I sell as well

I know a lot of you aren't on Facebook, Jay passed after what sounded like a fairly short but difficult battle. RIP Jay