RC10Talk - The Net's Largest Vintage R/C Community

The new gear diff FanRC trans requires drilling the motor plate but I don't think you drill the chassis at all. From what I've seen it's just a simple drill jig for the motor plate But yeah that's the main thing we concentrated on with our case- no drilling for ANY rc10, and any brace fits as well ...

I'm not going to lie, I would rather put my money where my mouth is and buy the conversion from you. At best, I'll send you an order for some parts instead of buying this release. Same here, I maybe late to the party, but I'd buy a conversion as well. I have already supported AE with the CC and 40t...

They don't sell a rear wheel that would work with the 12mm hex rear in that offset. I think it would add to confusion as well when buying wheels. It's already bad enough with the 1/4" and 3/16" offerings While they were busy copying your work, they could have made at least one new origina...