RC10Talk - The Net's Largest Vintage R/C Community

Last night, I launched a long print (ok, ot so long, it would have taken much more time on the E5+)...



The Big Bear / Super Wheelie 3 part chassis for dimensional test... Next will be in the Super Wheelie and Big Bear thread (later this afternoon, I won't have any time this morning)...

Spent almost the day reorganizing space, and did not move on any of my RC projects... This morning, I moved the Ender 5 Plus to the enclosure, and it allowed me to free some space under my desk to store car boxes... https://i.imgur.com/P21cqc1.jpg I'm pretty happy, as there is now additional room to...

I launched a print of Hunter rear tire this morning, with a target shore of 55A. The resin is a different one that the one I used for the Samurai and Ninja tires... First it has less odor, and it seems more fluid... We'll see if it prints correctly in a few hours, finger cross... In the meantime, I'...

And the first print of tire with the second resin candidate is done...


Need to post process it next... Still a lot of work to do, and 3 other tires to print for the Hunter...

Post processing was done. First a bath of IPA Alcoohol (not a fresh one), then remove the supports, then another bath with clean IPA; the two baths with agitation. Nex was drying with air compressor outside, inside, outside again... Then I let it dry alone for 30 minutes again... I only had an issue...