Rear end assembled and installed onto the chassis. Using Lunsford retro turnbuckles and RPM ends. I was planning to use these cool vintage grey units, but remembered they are for a larger diameter HD thread. RPM rear carrier and chassis brace finish off the slider.
I have had this HPI EB body in my stash for 20+ years, and have never had a truck that fit it ................ until now! :D The camera is playing tricks as usual, but the actual WB is within 1/4" of each other. I think it may actually fit up with the jg body mounts also, or close enough. eb bo...
I have to say it's harder to avoid scratching the screw heads than it is to get them aligned. Yes RogueIV, I feel you on the electrical wall plates and making sure the screw heads are aligned. I actually replaced all the electrical covers in my house with fancy screw free units. Problem solved there...