RC10Talk - The Net's Largest Vintage R/C Community

Traxxas Sledgehammer V1 (V2 shocks) Stock original type motor with original type heatsink. New XL-1 ESC with Sledgehammer / Boat heatsink. Rx case is original to truck with more modern guts inside. Servo is a more modern Traxxas unit made to look like original. Tub, bottom braces, front chassis bump...

This is my parts lot Team Car. https://www.rc10talk.com/viewtopic.php?f=35&t=46399 Mods are limited to RPM front arms, GT rear carriers, T3 slipper, and Vintage RC towers. Electronic consists of Tekin esc and receiver, Futaba S132 servo, and a Reedy Tru Stock motor. The body is a JConcepts Prote...

This is my RC10 FT on-road T4. It started off as an original first version T4 RTR roller with carbon chassis, A-arms & shock towers and no body. I then added AE factory team blue aluminum rear 0* hubs, motor plate, shock bushings & front hinge pin brace. Along with threaded AE FT buggy shock...

I had this car for quite a while. Last year I stripped it down to the chassis and completely rebuilt from there.
Build thread https://www.rc10talk.com/viewtopic.php?f=35&t=46632







Chuck

Tide Monte Carlo ss aerocoupe

Clodbuster conversion to shaft drive.

Build thread: https://www.rc10talk.com/viewtopic.php?f=118&t=41121

2023 MoonCruiser (aka Kyosho Nexxt)
Out-of-the-box design. Would look better cruising the surface of the Moon or Mars?
Along with the Tamiya Avante, the RC Elon Musk would most likely have in his office...

This is my proto based on the Jamara /Hobby World Valiant 2.
I build all the epoxy parts myself.
The body is a TBG jammin jay, with my paint scheme.

1998 Associated RC10GT #7072
Built with love and hop-ups







build thread
https://www.rc10talk.com/viewtopic.php?f=36&t=45996&hilit=lobonyc+rc10gt

1:8 Kyosho 4246 Williams Renault FW14 EP

https://www.rc10talk.com/viewtopic.php?f=30&t=44437

Here is an RC10 buggy that I am very fond of. I purchased this many many years ago from our good friend Don, RIP buddy. A few details, it has Andy's arms up front, RPM's on the back. Anodized chassis and such. LRP Runner speed control and a Futaba S3003 servo. Thanks Don. 20230308_155028.jpg 2023030...

This is the Outlaw ll...highly modified Tamiya Bruiser...here is a build thread
https://www.rc10talk.com/viewtopic.php?t=47544

Original Tamiya Midnight Pumkin (not rerelease)...ran hard for many years in early 2000s...set up on 10 cells and a trinity speed gems amber motor (long before days of brushless motors and lipo batteries). Clocked it at 48mph on gps. It was a handful and took a horrible crash. It was restored with a...

Proline rc10 hot trick truck conversion with original mip trans and steering

This is my RC10 A+ chassis 6 gear buggy. It's gone through a little bit of front end evolution to replace the nose tube setup and lower the bellcranks a bit. https://www.rc10talk.com/viewtopic.php?f=35&t=47355 RC10B6 chassis, trimmed and modified Trinity Modified Litespeed Litesink Hitec Shredde...