RC10Talk - The Net's Largest Vintage R/C Community

Pretty much a full boat Hot Trick conversion...nice!

Can anyone tell me the width of the front bulkhead where the inner hinge pin passes through? I trying to figure out if standard off road rc10 front arms would mount to this bulkhead. Thanks

The body is painted. Almost done....

Ok I might actually be done now... The original steering setup I made had pretty extreme bump steer. Just moving the suspension up and down it went toe in to toe out easy to see with the naked eye. I know some of the aftermarket Hot Shot chassis used a single RC10 bellcrank to smooth out the steerin...

It's pretty simple, Associated was still using a lot of the original RC10. No Stealth trans, 6 gear... Look at the short arm cars in this picture with the Kondo and Moore cars from RCMC UK's coverage: 1987-11 RCMC UK Moore Nr1 and Kondo Nr 5.JPG The Ultima was a fairly new car with longer arms, prob...

RC10 with oval conversion. Is that a McAllister front end? It also has a bunch of Andy's parts. Just wondering if it was a kit or just a bunch of parts put on. Thanks. Definitely a Mcallister lowering kit, which would do both ends of the car. Pretty typical to have all the Andy's parts (bumpers/bod...

I found Pukka Parts on Facebook, with this SRB conversion kit. It's more or less an MIP style setup.

Really nicely done stuff, a combo of frp and printed parts.

I came across some magnet wire at a surplus store. For fun I rewound an old stock motor blank. IT's not incredibly hard to make one that will spin up, the problem is making it perform. Mine spun on a turbo 30, but that's all I did with it.

These cars need the animated driver dudes like this...

https://youtu.be/RhRNdp3bT-0?si=v3bVn8PCRWPid8KE

SRB with Rc Channel upper and lower arm rear end, Scorpion shocks, Xtra speed chassis, and Dremel powered engineering...

Well, the first attempt at an off road track did not go well.