RC10Talk - The Net's Largest Vintage R/C Community

.

Well I suppose it's done!.. It's been a blast and really stretching my limits. That was fun!
Only thing left is to drive it... with COVID-19 all indoor tracks are closed and we have a foot of snow outside

Thanks for all the support in this build guys. You rock!

adam lancia wrote: ↑Thu Feb 29, 2024 5:58 am So the one piece axles would work with the Traxxas parts? Do you happen to know which specific part numbers I should be looking for?

Not off hand (I'm at work), but they are the regular 2WD truck parts

This is a AE axle in a Traxxas carrier.

Do you know if the Traxxas axle carriers fit the B4 c-hubs? I have adapted the smaller (5X8) bearing type. They are only used on the brushed Bandit buggy (VXL's use the larger one) now. Rustlers and Stampedes also used them in the past. The two sizes are interchangeable on Traxxas carriers but I ha...

adam lancia wrote: ↑Sun Mar 03, 2024 5:15 pm Dragging an oldie up from the depths...

Would a 60a sensor ESC be sufficient for a 17.5t combo? No racing, just playing around with my kids.

Thanks in advance!

yes

Here is the longer chassis. You can see in the photo where I circled where you can see it was extended the 8mm.

I believe the 2.4 CW trans used B2/B3/T3 internals and the 2.6 used B4/T4.