RC10Talk - The Net's Largest Vintage R/C Community

You folks are terrible. First I was tempted into a cheap 144001, now it's the Mini B.

Ordered from Amain. I have not even looked at which motors will fit.

I finished my Losi mini B pro roller today. I used the Hobbywing 18A ESC, 7800KV 2030 motor, CHNL 650 70c 2s battery, and Radiolink R4FGM receiver (buried under the wire burrito), and Emax es08md ii servo. The servo does not work with the supplied AL servo horn. Additionally, the supplied servo moun...

A DR10 was sitting idle with only a dozen runs on it, each one ended with the car sliding on its roof. After reading this thread https://www.rc10talk.com/viewtopic.php?f=114&t=47939 I started ordering parts. The chassis, shock towers, and front bumper were dirt cheap off of ebay. The v2 shocks, ...

So I like a challenge sometimes. I had built the DR10 to RB10 conversion car to race on carpet, it did pretty well. Then a B6.4 and a B74.1 followed me home and picked up the carpet duty. I'm a slave to impulse, what can I say? My local track unloaded the rental fleet of RB10 RTRs for dirt cheap so ...

Fusion 360 for those who are interested. I created the models that have to fit existing parts by inserting a lens distortion corrected picture as a canvas then scaled it based on the screw hole spacing then tracing it on a sketch layer. First try success for everything but the motor plate, I could n...

Oh, I can add yet another car that this monstrosity is using. DR10 trans internals, suspension with exeptions Dr10M front end, the bit that everything screws to. RB10 front tower, steering, probably motor and esc from a rtr. B5M trans case, rear tower, wing mount, rear arm mounts, v2 shocks B6.4 rea...