RC10Talk - The Net's Largest Vintage R/C Community

One part I needed to adjust was the front shock tower. I wanted to keep the chassis geometry for the shocks. But I wanted to center the steering servo head. I could have thought about adding more complexity using the two holes located at the rear end of the front shock tower walls, but I thought the...

It's lighter now but still going. I measured 8" in the middle of my back yard.

This Arsey 10 arrived. I'm not sure why the front wheels are in the back
.

A shot that IS by me, of what that view normally looks like.

That's unbelievable for where you guys are at. Hope it melts soon! Same here, kinda like been here done it, let’s move on lol. Wife and kids are enjoying it, but all I can think of at this point is that they are going to try and open the airport tomorrow and we will need to be there. Hoping it melt...

Hi everyone, this shall be a build thread of a little restoration/upgrading project. Starting point are three Outrages (Baja Stadium, ARR, and RTR) which I intend to make into two and run them as well. The RTR being in my posession for well over 25 years. 20 if which in my parents basement but that'...

A tracked RC in the snow would be a blast! 8) I've got a couple of 1/16 RC tanks , took one out in the snow once , snow iced up in the tracks almost straight away , no fun at all 😞 I've heard northern IL snow is far better specifically for tracked r/c than UK snow. It's a scientifically proven fact...

Finished the last improvement today. Knocked up an undertray from 0.5mm PETG. It won't help performance, but I think it's necessary considering the position of the cells. They can take an awful lot of hits from debris if you aren't using a full width chassis. 1.jpg Fitted. Bloody marvellous I reckon...

This morning, I adjusted shocks for this Zerda. Original shocks were 80 and and 90mm, but I find the rear should be shorten by 5mm. I started with some 85mm shocks. Rear are unchanged while front course is shorten by 5mm by insertion of a printed bearing on the piston shaft. https://i.imgur.com/X7fk...

One thing to note if using CA on PLA joints...

Depending on the amount of handling of the joint, certain PLA filaments will show CA vapor fogging worse than others. If the joined part is cosmetic, clean properly with isopropyl first and handle with care to avoid fogging.

Dusted these guys off, Parma Ski Tiger with a modern hardware set up, and my old H&M No Step 2 P mono race boat. Trying to encourage myself to do a little boating in the near future.

Finally done. All painted, stickered and threadlocked. Getting ready for a run on the weekend.

Unexpected home remodel project is really interrupting RC bench time (& budget) the last couple weeks. :evil: But still, taking small bites at projects and a few pics. (posting from my Iphone and the preview pics are all rotated screwy) First is one for the married guys. I’m using the wood stove...

Being a former fast electric boat racer, by habit, just about everyday of my life I look on eBay for vintage fast electric boats. Last week I found this and made a deal with the seller. New in box Parma Ski tiger supreme kit. Minus the matched 6 cell pack. Oddly enough it is packed in a Parma Follan...

home made versions of the adjustable CRP motor plates for clod, hornet, frog etc

our version...