RC10Talk - The Net's Largest Vintage R/C Community

Thanks gents for the nice words...appreciate it..even if I lose

coxbros1 wrote: ↑Thu Jan 09, 2025 4:25 pm Thanks gents for the nice words...appreciate it..even if I lose

It got my vote, and not because your my brother. Its because when you watch it run and hear it, your thinking, "what the fxck just happened!" And your heart is beating hard for 20 more minutes.

Waiting to see if the cops show up is the funnest part.

Kedal's paint schemes are my favourites. This month's entry is no exception. The $30 per run thread is priceless exciting entertainment. Good to know that you get 20 minutes enjoyment for this value, not only 1,xx seconds. I feel it's comparable to Scotch drinking :lol: But have I mentioned yet that...

We had about .5 inches of ice and snow last Sunday. Put about 60K people without power. Ours just came back yesterday. Just snow today. At least it's pretty to look at out the kitchen window.

Hope all the So Cal members are safe.

It's unfortunately bad for many in the northern part of LA where as the majority of the rest of the city is kinda in the clear for now. I'm about 7 miles from the nearest fire to me. Not gonna lie it was/still is scary as sh*t! Here was my view wednesday at 7am in the morning as I was on my way out ...

I am much further away in Orange County and work even further away in Riverside County. This was a shot I took from our carpool, as I sat in the backseat, out the front window of the car as we entered Orange County today. I cropped out the traffic, LOL.

https://youtu.be/zTOWi82Psuc?si=2xNkD4NiMxMwidGQ

Like this:

https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/11373708-homemade-brushed-esc-bec.html

Hey Guys, A few years ago, there was an article in the forums here about how early ESC's were made with some components of a servo. I believe it was Tamiyadan that did the original thread? Anyway I have a project in front of me that I would like to build a "replica" of one of those early ...

Rather than calling this an underguard, I should call this a rigidifier. 3mm Kydex sheet, laser cut. I made a projection of the front on the plan, and added 1mm in length at the front extended all holes by 1mm to the front, to take provision for the bent. To bent it : - a piece of wood on the rear/l...

Polished the rear suspension arm pivot balls and made carbon fibre reinforcing plates for the arms. Machined double wheel bearing adaptors for the rear. Each housing is 10mm wide, so they fit two 5x10x4mm bearings. I'm using Kyosho OT-18 stub axles instead of the stock items. 1.jpg This is so I can ...

Unfortunately the weather isn't cooperating here..ice melted but 20mph winds and cold....that's just too windy to run it..I will postpone the launch until a nicer day

Dadio wrote: ↑Sun Jan 19, 2025 6:33 am Just another 9 votes and it's all mine !

Maybe a water pipe will burst and, when the counting resumes, you are mysteriously leading by 9 votes...