RC10Talk - The Net's Largest Vintage R/C Community

Glad I saved my money then.

Will the TC5 outdrives work with the RC10T stealth transmission?

and yes you can use the mounts, just use a .030 shim washer and that should give you the squat you need Got confused in your posts. Are you stating that the arms will work with modifications and the washer for needed squat, or they will work without modifications but use the washer for necessary sq...

I haven't had the car to the track to notice the difference yet. I'm also not as experienced as many of the others on here too. All I can say at this point is the they fit without any problems. Wish I could be more helpful. I had not purchased them yet. But I will now. Worth a shot. I just picked u...

vintage AE wrote:

Snorman70 wrote:These are stated to be 3 degree mounts. Do you think they will work?

These do work, I have them on my rc10 pan runner, and the gold ones being referred to are made by Atlas on here, they work too.

Will they work without the washer? Will the squat be adequate enough?

klavy69 wrote:

Snorman70 wrote: Went with a ft t3 front end to widen the stance up.
Todd

Is then why there is listing for front inline axles that say wide? How much of a better apperance does it give the truck, also does it make it easier to drive?

3/16 is the way to go if its gonna be anything more than a shelfer. You get better bearing life with a 3/16 over a 1/4 any day. bearing ball is a little bigger making it a little bit sturdier for loss of a better way to describe it I guess... Todd Is there an aftermarket aluminum set of castors and...

What other trucks came stock with 1/4" axles and carriers that will work with the RC10T? Are the others, such as the T3, T4 all 3/16" axles? Is it worth converting to the 3/16" axles because parts seem to be easier to find.

SteveK wrote:Definitely the anti-squat, and possibly the toe-in as well. I believe the rear arm mounts came with 0, 1-1/2, and 3 degrees of toe-in, but anti-squat was the same on all of them.

Thanks for the information. I will have to buy them to find out. lol It's only money, what the hell.

These are stated to be 3 degree mounts. Do you think they will work?

That is pretty cool. Did you have the shock bodies chromed also, or are they painted?

That's correct; not sure about the toe-in, but the GT rear arm mounts don't have any anti-squat molded in. You can use a washer under the mount at the front screw. The holes are very close, if not exact, but you'll need to enlarge the holes a little for an 8-32 screw. What are you meanwhen you say ...

Thanks for the information.

Can you use the battery two cup method that I have seen people use for the Rc10T's? Will the rear suspension mount for the GT also fit the RC10T?

I know that the front bulkheads are the same, but will the GT rear bulkhead work for the RC10T?